[gmx-users] GROMACS command for energy calculation
Mark.Abraham at anu.edu.au
Mon Aug 27 00:07:03 CEST 2012
On 27/08/2012 8:01 AM, Acoot Brett wrote:
> Dear Justin,
> In the internet there is the following content. But if I need to measure the non-bonded energy between residues within a protein, or between fragments within a protein, can you advise on how to set up the energygrp?
> Energy group exclusions
> Pairs of energy groups for which all non-bonded interactions are excluded.
> An example: if you have two energy groups Protein and SOL,
> energygrp_excl = Protein Protein SOL SOL
> would give
> only the non-bonded interactions between the protein and the solvent. This is
> especially useful for speeding up energy calculations with mdrun -rerun and for excluding interactions within frozen groups.
> ----- Original Message -----
> From: Justin Lemkul <jalemkul at vt.edu>
> To: Acoot Brett <acootbrett at yahoo.com>; Discussion list for GROMACS users <gmx-users at gromacs.org>
> Sent: Monday, 27 August 2012 7:09 AM
> Subject: Re: [gmx-users] GROMACS command for energy calculation
> On 8/26/12 5:02 PM, Acoot Brett wrote:
>> Dear All,
>> After the production MD has been done, does GROMACS has a command which can calculate the interaction energy between any 2 residues in a frame of structure from the MD?
> Assuming you have made proper use of energygrps in the .mdp file, you can extract nonbonded terms between these groups from the .edr file using g_energy. If you have not set energygrps, you can create a new .tpr file and use mdrun -rerun to recalculate the energies from an existing trajectory or snapshot.
> -- ========================================
> Justin A. Lemkul, Ph.D.
> Research Scientist
> Department of Biochemistry
> Virginia Tech
> Blacksburg, VA
> jalemkul[at]vt.edu | (540) 231-9080
More information about the gromacs.org_gmx-users