[gmx-users] Flat-bottomed position restraint set

[liuyong_1007 at dicp.ac.cn]

Hi Justin!
I use the geometric center of the sphere as the reference coordinates. However, there are still water molecules escaping to the vacuum. Is there other way to aovid this ?

Best regards,
Yong Liu



liuyong_1007 at dicp.ac.cn

From: Justin Lemkul
Date: 2014-11-12 21:54
To: gmx-users
Subject: Re: [gmx-users] Flat-bottomed position restraint set


On 11/12/14 8:08 AM, liuyong_1007 at dicp.ac.cn wrote:
> Dear Gromacs users!
>
> I use the flat-bottomed position restraints to avoid the molecules to escape from the clusters to the vacuum. The parameters of the restraints on water molecules are shown as follow:
> #ifdef POSRES_WATER
> ; Position restraint for each water oxygen
> [ position_restraints ]
> ;  i   funct       g         r(nm)       k
>     1    2        1          3         30.0
>     2    2        1          3         30.0
>     3    2        1          3         30.0
> #endif
> However, water molecules still escape away from the cluster to the vacuum after about 100 ns MD run at 550K. What should be done with the restraints to avoid the water molecules to escape to the vacuum?
>

Are you using suitable reference coordinates passed to grompp -r?  If you're 
not, then the reference coordinates are whatever is in grompp -c, which means 
your water molecules can deviate up to 3 nm from that position without penalty. 
  For a sphere, the reference coordinates for the water should be the geometric 
center of the sphere.

-Justin

-- 
==================================================

Justin A. Lemkul, Ph.D.
Ruth L. Kirschstein NRSA Postdoctoral Fellow

Department of Pharmaceutical Sciences
School of Pharmacy
Health Sciences Facility II, Room 629
University of Maryland, Baltimore
20 Penn St.
Baltimore, MD 21201

jalemkul at outerbanks.umaryland.edu | (410) 706-7441
http://mackerell.umaryland.edu/~jalemkul

==================================================
-- 
Gromacs Users mailing list

* Please search the archive at http://www.gromacs.org/Support/Mailing_Lists/GMX-Users_List before posting!

* Can't post? Read http://www.gromacs.org/Support/Mailing_Lists

* For (un)subscribe requests visit
https://maillist.sys.kth.se/mailman/listinfo/gromacs.org_gmx-users or send a mail to gmx-users-request at gromacs.org.